Hello, The Terminal Server Licensing uses port 135 and one port dynamically allocated above 1024. I cannot have all the ports open via my firewall.
Hence, I followed the article: http://go.microsoft.com/fwlink/?LinkId=48218
Per above article, I used regetd32.exe on the license server and configured above registry keys and then rebooted. I also configured my firewall to allow traffic on the range 5000-5100 on Licensing Server; the same range I while following above article.
Now, I am not able to add the License server IP address in the RD session host server as the mmc snap-in hangs and I have to kill it.
If I allow incoming connection to the license server on all ports from the RD session host sever ( this setting was done in my firewall) and I could immediately add the License server IP address to the RD session host server and it worked like a charm.
So, this mean, whatever mentioned in above tech-article is not working for me. OR I am not sure what I could have done wrong.
Could you help me figure out how to specify this custom port used by the license server so that I can configure my firewall respectively. Opening the firewall for all the ports is not an option at all.
Hence, I followed the article: http://go.microsoft.com/fwlink/?LinkId=48218
Per above article, I used regetd32.exe on the license server and configured above registry keys and then rebooted. I also configured my firewall to allow traffic on the range 5000-5100 on Licensing Server; the same range I while following above article.
Now, I am not able to add the License server IP address in the RD session host server as the mmc snap-in hangs and I have to kill it.
If I allow incoming connection to the license server on all ports from the RD session host sever ( this setting was done in my firewall) and I could immediately add the License server IP address to the RD session host server and it worked like a charm.
So, this mean, whatever mentioned in above tech-article is not working for me. OR I am not sure what I could have done wrong.
Could you help me figure out how to specify this custom port used by the license server so that I can configure my firewall respectively. Opening the firewall for all the ports is not an option at all.